Publicidad
Idiomas disponibles
Idiomas disponibles
MOUNTING THE BARS
Steps to follow:
1.
Release the clamping handle (2) until the accessory bar
snaps in gently.
2.
Pull out the safety pin (1) and push the bar into the joint
until it reaches the maximum depth. Make sure the drive
rod fits properly into the power take-off shaft drive.
3.
Turn the accessory bar until the safety pin snaps into the
accessory bar housing.
4.
Tighten the lever (2) until you have checked that the
accessory bar is securely fastened.
MOUNTING THE SAFETY GUARD
1.
Remove the two bolts and the baffle plate with an Allen wrench and set aside.
2.
Place the deflector guard over the gear head.
3.
Secure the guard in place with the two bolts you previously put aside, using the Allen wrench.
4.
Place the blade in the blade guard and secure it with the two screws.
INSTALLING THE METAL DISC
1.
Place the inner bracket on the shaft and rotate it until the holes in the shaft and bracket
match. When they match, fix them with the aid of the enclosed L-shaped wrench (1).
2.
Place the outer bracket on the shaft, following the inner bracket, facing the blade.
3.
Place the disc on the outer support of the shaft so that the hole in the blade corresponds
to the socket in the outer support.
4.
Place the cup washer on the outer bracket and tighten the nut counterclockwise.
2
1
75
EN
1
Publicidad
