Publicidad
Idiomas disponibles
Idiomas disponibles
10.5
Bevel cutting
▪
Align the line of cut with the 45° blade guide notch on the base when making 45° bevel
cuts.
▪
Make a trial cut in scrap material along a guideline to determine how much you should
offset the guideline on the cutting material.
▪
Adjust the angle of the cut to any desired setting between 0 and 45°.
11 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
11.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
11.2
Lubrication
From time to time, apply a drop of oil to the thread of the lock screw.
12 TECHNICAL DATA
Rotation speed
Blade size
Max cutting depth
Rated voltage DC
Maximum cutting capacity 90°- 90°
Maximum cutting capacity 45°- 90°
Bore size
Adjustable angle
Number of teeth
Soft grip
LED work light
13 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
aw (Vibration)
Copyright © 2024 VARO
POWDP25200
-1
4000min
165mm
55mm
20V
55mm
38mm
20mm
Yes
24T
Yes
Yes
93 dB(A)
104 dB(A)
4,4 m/s²
P a g e
| 10
K = 1.5 m/s²
www.varo.com
EN
Publicidad
