Jabra GN 9120 Manual Del Usuario página 4

Note: By default, the GN 9120 is set to the DHSG interface.
Note that a special version of the GN 9120 is required.
To set up your GN 9120 to work with the AEI (or RHL) interface, complete the fol-
lowing:
1. Hold the headset in your hand with its on-line indicator facing you.
2. Press the volume + and volume – buttons on the headset simultaneously for 6
seconds, until the headset's on-line indicator fl ashes rapidly.
3. You are now in interface switching mode, and can set the GN 9120 to work with
your telephone's interface.
4. Using the volume + button to move right
and the volume – button to move left, select
the required interface.
The base unit's 3 indicators show which
interface the GN 9120 is in. See the illustra-
tion to determine the type of interface.
Note: If more than 15 seconds elapses
without pressing the volume + or volume
– buttons, the last selected interface will be
activated.
5. To exit the interface switching mode, press
the volume + and volume – buttons simul-
taneously for 6 seconds.
6. Only with the GN 1000 RHL: complete the setting up procedure according to its
user guide.
Features and customisation
Multifunction button (2d)
The multifunction button serves several functions, depending on
how long the button is pressed for.
6
GN9120_contents_RC_new2_EU.indd 6-7
RHL DSHG AEI
Volume button
– +
4
Link icon
6
Mute icon
5
Charge icon
Functions Press momentarily
Mute x
Un-mute x
Answer/make call x
End call
Conference mode x
Tone control adjustment
Functionality of the + and – buttons (2b & 2c)
The + and – buttons serve several functions, depending on how long the button is
pressed for.
Functions Press momentarily
Volume + x
Volume - x
Transmit volume x
adjustment (+/- simultaneously)
Clear dial tone adjustment
In order to hear a dial tone, you must set the correct dial tone setting.
Complete the following:
1. Put on your headset.
2. Lift the telephone's handset and listen for a dial tone in your head-
set.
3. If there is no dial tone or it is not clear, move the telephone termi-
nation switch (1e), at the rear of the base unit, along the A-G range
until the dial tone is clear. If the dial tone is just as clear in position
A as in position G, leave the switch in position A.
Transmit volume adjustment
Adjust the volume of transmitted sound according to personal preference. To adjust
the volume:
1. Make a telephone call and ask the person you are calling to assist you.
Press for 2 sec Press for 6 sec
x
x
7
09-10-2003, 15:29:31