Jabra GN 9120 Manual Del Usuario página 6

the "R" inside the earhook with the square hole on the headset, and gently press the
ear hook onto the headset receiver.
2. Attach the earhook to the earhook ring's clutch.
After attaching the earhook, you may now adjust the headset to be worn on your right
or left ear, depending on personal preference. See the changing wearing ear section
for instructions.
Changing wearing ear
Headband (3) wearing style.
Your headband allows you to wear your headset on your right or left
ear, according to personal preference. Simply rotate the boomarm 180
degrees and your headset is ready for wearing on the other ear.
Note: The boomarm cannot be rotated a full 360 degrees. Do not force
the boomarm when it cannot be rotated any further.
Earhook (4) wearing style.
With an earhook, you can wear your headset on your right or left ear, according to
personal preference. Complete the following steps:
1. Rotate the boomarm 180 degrees.
Note: The boomarm cannot be rotated a full 360 degrees.
Do not force the boomarm when it cannot be rotated any further.
2. Detach the earhook ring, turn it 180 degrees and click it back on to the receiver.
3. Detach the earhook from the earhook clutch.
4. Insert the earhook into the opposite side of the earhook clutch.
Note: The buttons on the headset must be facing upwards.
10
GN9120_contents_RC_new2_EU.indd 10-11
Conference mode
Using the conference mode, more than one headset may be joined
to a telephone conversation via the base unit. The headset you use
with your base unit is the master headset.
1. Lift your master headset out of the base unit.
2. Initiate or answer a call. See the answering and making tele-
phone calls section.
3. During the telephone call, place an additional headset into the
base unit and leave it untill all lights stop fl ashing and only the
battery indicator is on. Remove the new headset from the base
unit - a beep will then be heard in the master headset, after
which you have 15 seconds to accept the additional headset.
4. Accept the additional headset by pressing the multifunction but-
ton momentarily.
5. An additional headset leaves the conference call by pressing its
multifunction button for 2 seconds.
6. The conference mode is terminated when:
• the master headset is placed in the base unit
• or the master headset's multifunction button is pressed for 2
seconds (this will end the call)
Note: Repeat steps 3-5 to add more headsets to the conference
mode. Up to 4 headsets may participate in the conference mode.
Answering and making telephone calls
Answering telephone calls:
To answer a telephone call:
1. Lift the telephone's handset out of its cradle when alerted to an
incoming call.
2. Remove the headset from the base unit. The link will be estab-
lished and the on-line indicator (1a) on the front of the base unit
will light.
To end the call, place the headset in the base unit and replace
the telephone's handset to its cradle.
11
09-10-2003, 15:29:33