Sharp SJ-BA10IEXI2-EU Manual De Uso página 11

CHAPTER -3: USING YOUR FRIDGE FREEZER
Cooler temperature settings
• Initial temperature value for the Cooler Setting Indicator is +4 °C.
• Press the cooler button once.
• When you first push this button, the last value will appear on the cooler setting indicator.
• Whenever you press this button, a lower temperature will be set. (+8°C, +6°C, +5°C, +4°C, +2°C,
Super cool)
• When you push the cooler set button until the Super cool symbol appears, and if you do not push
any button within 1 second, Super Cool will flash.
• If you continue to press the button, it will restart from +8°C.
• The temperature value selected before Holiday Mode, Super Freeze Mode, Super Cool Mode or
Economy Mode is activated and will remain the same when the mode is over or cancelled. The
appliance continues to operate with this temperature value.
Freezer temperature settings
• The initial temperature value for the Freezer Setting Indicator is -18°C.
• Press the set freezer button once.
• When you first push this button, the last set value will blink on the screen.
• Whenever you press this button, a lower temperature will be set (-16°C, -18°C, -20°C, -22°C,
-24°C Super freeze).
• When you push the set freezer button until the Super freeze symbol appears, and if you do not
push any other button within 1 second, Super Freeze will flash.
• If you continue to press it, it will restart from -16°C.
• The temperature value selected before Holiday Mode, Super Freeze Mode, Super Cool Mode or
Economy Mode is activated and will remain the same when the mode is over or cancelled. The
appliance continues to operate with this temperature value.
Warnings About Temperature Adjustments
• Your temperature adjustments will not be deleted when an energy breakdown occurs.
• It is not recommended that you operate your fridge in environments colder than 10°C.
• Temperature adjustments should be made according to the frequency of door openings, the quantity of food
kept inside the fridge and ambient temperature of the placement of your fridge.
• Your fridge should be operated up to 24 hours according to the ambient temperature without interruption after
being plugged in, this is so it is completely cooled. Do not open the doors of your fridge and do not place food
inside it during this period.
• A 5 minute delay function is applied to prevent damage to
the compressor of your fridge, when you take the plug out
and then plug it back in again after an energy breakdown
has occurred. Your fridge will start to operate normally after
5 minutes.
• Your fridge is designed to operate in the ambient
temperature intervals stated in the standards, according
to the climate class stated in the information label. We
do not recommend operating your fridge out of the stated
temperatures value limits in terms of cooling effectiveness.
Temperature indicator
In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in
the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make sure the message "OK"
appears on the temperature indicator. If « OK » does not appear, this means temperature has not been set
properly
It may be difficult to see the indicator, make sure it is properly lit.Each time the temperature setting device is
changed, wait for the stabilisation of the temperature inside the appliance before proceeding, if necessary,
with a new temperature setting. Please change the position of the temperature setting device progressively and wait at
least 12 hours before starting a new check and potential change.
NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh food into the appliance,
it is normal for the indication "OK" not to appear in the temperature setting indicator. If there is an abnormal build up
of ice crystals of ice crystals (bottom wall of the appliance) on the refrigerator compartment, evaporator (overloaded
appliance, high room temperature, frequent door openings), put the temperature setting device on a lower position until
compressor off periods are obtained again.
Climate Class
T
ST
N
SN
EN -9-
Ambient Temperature
Between 16 and 43 (°C)
Between 16 and 38 (°C)
Between 16 and 32 (°C)
Between 10 and 32 (°C)
OK
C
o