Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATIONS
•
The tool is not suitable for impact wrenches. Using an impact wrench can cause components
to burst and flying component fragments can cause injury.
•
Always use a workshop manual for detailed instructions.
•
Always grease the tool threads before using the tool.
•
Check and replace any damaged tool components if necessary.
ENVIRONMENTAL PROTECTION
Dispose of this product at the end of its working life environmentally. Recycle unwanted
materials instead of disposing of them as waste. All packaging should be sorted, taken to a
recycling centre and disposed of in a manner which is compatible with the environment.
Contact your local solid waste authority for recycling information.
USE
1. Choose the hydraulic spindle (1) or strike spindle (2) and insert it into the pull arm disc (4).
When using the hydraulic spindle, the centering tip (5) must be attached to the front of the
hydraulic piston with or without an extension.
2. Select number of pull arms (3).
•
4 pull arms for wheel hubs with 4 wheel nuts or bolts
•
5 pull arms for wheel hubs with 5 wheel nuts or bolts
•
3 pull arms for wheel hubs with 6 wheel nuts or bolts
3. Install the pull arms (3) on the pull arm disc (4) by sliding the slot in the pull arm eye over the
opening (A). Attention: Before use, turn the pull arms on the pull arm disc to an offset position
from the opening (A).
4. Fasten the pull arms (3) to the wheel hub (C) using original wheel screws or bolts (B).
5. Pre-tension the hydraulic spindle (1) on the knurling by hand.
6. Check all components for correct seating.
7. Turn the sliding bar clockwise to slowly push out the drive shaft. Re-tightening of the hydraulic
spindle may be necessary if the way of the hydraulic piston is not sufficient. To do this, turn the
sliding bar several turns counter-clockwise and the hydraulic spindle on the knurl as far as
possible in direction of the drive shaft stub.
8. After work, return the hydraulic piston to its initial position by pressing the hydraulic spindle
against a workbench, for example, and turning the sliding bar counter-clockwise. Be careful not
to unscrew it too far, otherwise the thread of the sliding bar may fall out of the hydraulic spindle.
OCCUPATIONAL SAFETY
Always wear safety glasses, work gloves and
non-slip safety shoes when using this tool.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
