Publicidad
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps:
PROBLEM
Leakage under faucet handle
The aerator has an
irregular or reduced
water flow
The water pressure
is low.
There is a low flow of
water.
CAUSE
Bonnet nut has
come loose
The aerator is dirty or
mis-fitted
The connector underneath
the deck is clogged with debris
The aerator is clogged
The screen filter in the hose
connectors is dirty.
ACTION
Remove the cover button. Loosen set
screw with hex wrench. Remove
the handle. Unscrew cap. Tighten
bonnet nut with an adjustable wrench.
Remove the aerator and check for debris.
Ensure that the rubber washer is properly
installed.
Turn off the water supply and disconnect
the connector / aerator. Unscrew the
connector / aerator and clean under
running water. Screw the connector /
aerator back.
Test water flow. If water pressure is still low
then replace the connector / aerator.
Turn off the water supply at water valve
and unscrew the hose connectors from
water supply lines. Clean the screen in the
water lines with hot water, removing any
debris or calcium build up.
25
Publicidad
