Behringer B1C Guia De Inicio Rapido página 8

14
B1C
B1C Controls
(1)
(6)
(7)
(2) (3) (4)
(5)
(8)
(9)
(10)
(11)
(12)
(EN) Step 2: Controls
1. INPUT A/B - combination jacks accept input
signals over XLR balanced, ¼" TRS balanced,
or ¼" TS unbalanced connectors.
2. BASS control - cuts and boosts the level of
the low frequency range.
3. TREBLE control - cuts and boosts the level of
the high frequency range.
4. VOLUME control - adjusts the volume level
of the input.
REVERB control - adjusts the level of
5.
reverberation.
6. CLIP LED - turns on when the level of the
audio signals going into any input is too high.
7. PAIR/TWS - use to pair the B1C with a
Bluetooth device and to pair with another
B1C for True Wireless Stereo operation (TWS).
The LED shows the status.
AUX INPUT - 3.5 mm stereo input jack.
8.
9. LINE OUTPUT jack - sends a combined
signal from all inputs, out over a balanced
TRS connection.
10. AC/POWER LEDs - show on/off status and
battery status.
The left LED indicates power on/off (Amber)
The right LED indicates battery status :
Green solid: battery is full
Green flashing: battery charging
Red: battery is low
11. AC/POWER switch - turns the unit ON and
OFF. When ON, the B1C will run on AC power if
the power cord is connected to a live AC power
source, or it will run on internal battery power.
12. POWER SOURCE jack - accepts the included
IEC cable. Only use the supplied cable.
15
Quick Start Guide