AENO EG1 Guia De Inicio Rapido página 8

grill falls into water, you must unplug it first, and only then remove it from water
with gloved hands. Never use the grill if it's damaged or its power cord is
broken. Do not try to repair the device on your own. Always install the grill on a
flat and stable heat-resistant surface in a well-ventilated area. If the grill
contains too many food products at once, so it can hardly be closed, never use
force to close it as you may damage the device. To avoid fire hazard, never leave
the switched-on device unattended. The grill's cover panel ❷ must be closed
before connecting it to the mains. After cooking, the cooked food shall be
removed from the grill using wooden or heat-resistant spatula only. Do not use
a sharp fork or knife to remove food products from the grill as this may damage
its non-stick coating.
Initial Setup
Unpack the grill and reel out its cable, but do not plug it into the mains socket.
Make sure that the drip tray ❽ is installed on the plate ❾ (see Figure b) at the
rear of the grill's body ❺ (see Figure a). Press the upper lock button ❹ to
remove the upper removable plate ❼ , and then press the lower lock button ❹
to remove the lower removable plate ❻ by simply pulling it. Wash the
removable plates in warm soapy water, and then wipe them dry with a soft
cloth. These parts can also be washed in the dishwasher. Please note that
plates should be washed and dried after each cooking operation. Install both
the upper and the lower grill plates back in place before use. Put the grill on a
flat and stable heat-resistant surface.
Note. Removable plates are interchangeable and reversible. One surface of the
plate is ribbed, and the other is flat. Food products can be cooked on any of the
above surfaces. While installing, make sure that the drip tray drain ❿ is facing
backwards, because the grease must be drained away into the drip tray ❽ .
When used for the first time, removable plates shall be oiled with a thin layer
of cooking oil using a paper towel. If necessary, oil the surface again to ensure
proper operation of the non-stick coating. For the first time, the device shall be
heat up without food products for about ten (10) minutes. A small amount of
light smoke or odor is deemed to be normal and harmless.
8 aeno.com/documents