Descargar Imprimir esta página

Atlantic PD300 Manual Del Producto página 2

Ocultar thumbs Ver también para PD300:

Publicidad

Idiomas disponibles

Idiomas disponibles

Introduction
Thank you for selecting the Atlantic Pond De-Icer. Before using this De-Icer please take a
moment to review this manual.
To avoid an accident do not use the De-Icer in any way other than as described in this
manual. Please note the manufacturer cannot be responsible for accidents arising because
the product was not used as prescribed. Read all instructions and keep this manual as a
reference in case questions arise during use.
Prior to Operation and Installation
Before operating De-Icer, check for any damage to De-Icer and power cable that may have
occurred during shipment.
Caution
• DO NOT operate this product under any conditions other than those for which it is specified.
Failure to observe this precaution can lead to electrical shock, electrical leakage, fire, water
leakage or other problems.
• The De-Icer operates at 110/120 volt 60 Hz, please only use with a power supply voltage
within 110-120 volt 60 Hz.
• Please make sure that the power plug and the AC outlet receptacle are protected and away
from water to prevent accidental electric shock or short circuit.
• This De-Icer has been evaluated for use in water only. Always operate while fully immersed.
• Dry operation will cause the De-Icer to overheat/malfunction, leading to electrical leakage,
shock or premature failure.
• Always turn off power or unplug the De-Icer prior to performing any maintenance or placing
your hands into the water.
• CAUTION:
TO PROVIDE CONTINUTED PROTECTION AGAINST THE RISK OF ELECTRIC SHOCK,
CONNECT TO PROPERLY GROUNDED OUTLETS ONLY.
• WARNING:
RISK OF ELECTRIC SHOCK - THIS DE-ICER IS SUPPLIED WITH A GROUNDING
CONDUCTOR AND GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK OF ELECTRIC
SHOCK, BE CERTAIN THAT IT IS CONNECTED ONLY TO A PROPERLY GROUNDED, GROUNDING
TYPE RECEPTACLE.
Electrical Safety
To provide continued protection against risk of electric shock:
• Electrical wiring should be installed by a qualified electrician in accordance with all
applicable safety regulations.
• De-Icer must be connected to a properly grounded receptacle outlet, acceptable for outdoor
use and protected from snow and rain, immediately adjacent to the location where the De-Icer
will be used.
• Incorrect wiring can lead to a De-Icer malfunction, electrical shock or fire.
• De-Icer should operate on a designated, 110/120 volt circuit.
• De-Icer must be protected by a ground fault circuit interrupter (GFCI).
• De-Icer must be plugged into a standard, properly grounded, three pronged outlet.
• Route the supply cord and locate the heater so as to be protected from damage by livestock
• Do not use extension cords.
Safety Instructions
• Inspect the power cord before using. Make sure the cord does not become excessively bent
or twisted and does not rub against a structure in a way that might damage it.
• Always disconnect the power supply before doing any maintenance, when not in use, before
removing from water or placing your hands into the water to which this De-Icer is immersed.
• The De-Icer should not be used if the electrical supply cable is damaged in any way. If a
cable with damaged insulation is submerged in water, there is danger of water seeping
into the De-Icer and causing a short. The electrical cable cannot be replaced. If the cord is
2

Publicidad

loading

Este manual también es adecuado para:

73986