Atlantic TWVSC Manual Del Producto página 3

• TidalWave VSC must be plugged into a standard, properly grounded, three
pronged outlet.
Safety Instructions
• Do not lift, lower or handle the VSC by pulling on the electrical cord. Make sure the
electrical cable does not become excessively bent or twisted and does not rub against a
structure in a way that might damage it.
• Always turn off power or unplug the pump powered by the VSC prior to performing any
maintenance or placing your hands into the water.
ATTENTION
Installation
Ensure that the VSC is within reach of a
properly grounded GFCI outlet, and the
electrical cord of the pump that will be used.
Mount the TidalWave VSC in the desired
location using two weather-resistant screws
in the mounting slots located on the back of
the controller. The slots allow the VSC to be
easily removed from the mounting screws to
access the pump connection for servicing. The
VSC should be mounted above the ground
on a wall or post away from direct sunlight
and protected from weather exposure. Place a
piece of tape over the two keyhole slots on the
back of the Variable Speed Control, then make
two holes in the round part of the keyhole with
a pen or screw. Remove the tape and place it,
with the holes level and centered, on the wall
or post. Set each screw in the center of each
hole and drive them almost all the way in,
leaving about an eighth inch space between
the screw head and the post.
Before setting the unit on the screws, open
the weatherproof output port on the bottom
to reveal the pump connection outlet. A cord
lock feature has been incorporated into the
VSC to secure the pump cord and prevent it
from being accidentally removed from the
power outlet. Remove the cord retention clip
and plug the pump into the output port (Fig.
2). Replace the cord retention clip to secure
the pump cord, then replace the door to keep
out weather and insects. (Fig. 3) Slip the unit
over the screws and pull it down to snug it
into place. Plug the VSC into a standard 120V
electrical outlet to finish the installation.
The TidalWave VSC is not a safety device. It will not protect
against pump damage cause by overheating due to low
water operation.
Fig. 1
Fig. 2
Fig. 3
3