Publicidad
Idiomas disponibles
Idiomas disponibles
12 - Controller CAREL
EN
During normal operation, the controller displays the value of the probe set using parameter/4(=1
ambient probe, default,=2 second probe, =3 third probe).In addition, the display has LEDs that
indicate the activation of the control functions(see Table 1),while the 3 buttons can be used to
activate/deactivate some of the functions (see table 2).
LEDs and associated functions
Tab.1
function
icon
Compressor
fan
defrost
aux
alarm
clock
Table of functions activated by the buttons
Tab.2
button
Setting the set point(desired temperature)
-press SET for 1s the set value will start flashing after a few moments;
-increase or decrease the value using UP or DOWN;
-press SET to confirm the new value.
Switching the device ON/OFF
Press UP for more than 3s. the control and defrost algorithms are now disabled and the instrument
displays the message "OFF" alternating with the temperature read by the set probe.
Manual defrost
Press for DOWN more than 3s (the defrost starts only the temperature conditions are valid).
Continuous cycle
Press UP and DOWN together for more than 3s.
31
normal operation
ON
on
on
on
output on
all
RTC fitted and enabled, at least 1 time band set
normal operation
pressing the button alone
up
more than 3s toggle ON/OFF
ON/OFF
down
more than 3s: start/stop defrost
defrost
set mute
-1s: display/set the set point
-more than 3s: access parameter Setting
menu(enter password 22)
-mute audible alarm (buzzer)
OFF
off
off
off
output off
no alarm
RTC not fitted or disabled, not even 1 time band set
start up
pressed together
pressed
together
-
start/stop continuous
cycle
Pressed
start
parameter
reset procedure
start up
blink
request
ON
request
ON
request
ON
-
ON
-
ON
-
ON if RTC fitted
together
for
1s
display
firmware vers. code
for 1s RESET current
EZY set
Publicidad
