Quick installation guide
• the problem-free operation is hindered due to the installation of external
objects and / or objects that are not purpose-conformant in the opening
zone, the locking system or within the keeps;
• the locking system or the keep is manipulated in such a way that their design;
• mode of operation or function is changed;
• the door is drilled through in the area of the lock housings or of the lock rod
once the lock has been installed;
• the dead bolt projection or other locking components are employed
contrary to their intended purpose, as a means to hold the door opened;
• the handle's wire is driven through the spindle with force;
• the lock components are installed improperly or are tampered with, e.g. by
painting over moveable parts such as the bolt or the latch;
• loads exceeding those of normal manual force are transmitted via the safety
key onto the lock system;
• perform a manual or mechanical locking or unlocking during the motor is
working;
• the handle is turned counterclockwise or if a force greater than 150 N is
exerted on the handle;
• the clearance between the door frame and sash is increased or decreased,
which would for instance result from readjusting the hinge plates or from
lowering the door;
• if auxiliary lifting tools or other tools are used to open or close the lock;
• the handle and key are used at the same time;
• the lock is opened / closed with objects not intended for that purpose;
• the size of the door opening deviates from the specifications prescribed.
1.4 Explanation of symbols
Flags are used to identify important information in this quick installation guide.
Flags such as DANGER or CAUTION indicate the degree of hazard.
It is imperative that you do follow the measures listed to avoid safety hazards!
DANGER!
This warning symbol and signal word is used to identify a
high-risk hazard that will result in immediate death or serious
injury if not avoided.
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.com ∙ Subject to technical changes
blueMatic EAV4 / EAV4+
5
5095553
EN
1