Publicidad
Idiomas disponibles
Idiomas disponibles
(2) Installing the gas hob
This appliance should be installed by a registered Gas Safe Engineer!
Gas connection
The gas connection must be located in position where the stop tap is accessible.
The end of the inlet connection point of the gas hob has a 1/2" thread that allows for:
■
A fixed connection
■
Connection using a flexible pipe
The watertight seal supplied must be inserted between the manifold outlet and the gas supply.
You must prevent the pipe from coming into contact with moving parts of the kitchen unit (for example, a
drawer) and prevent access to any spaces which might become obstructed.
Danger of leaks!
If any connection is handled, check the seal.
The manufacturer is not liable for any connection leaking, after being handled.
Gas Specifition
Gas type &
Model
pressure
G20 20mbar
JAMA230BN
G30 29mbar
JAMA3BB
G20 20mbar
JAMA3BN1
G30 29mbar
JAMA3BX1
G20 20mbar
JAMA4BX/
JAMA4BX1A
G30 29mbar
JAMA4BN1
G20 20mbar
JAMA4BN
G30 29mbar
JAMA4BX1
JAMA575BN
G20 20mbar
JAMA575BX
G30 29mbar
JAMA590BN
Heat input and orifice size marked(mm)
Triple-Crown
3.3kW(240g/h)
3.0kW(219g/h)
/
/
1.28
0.93
/
/
1.28
0.93
1.28
0.93
EN-17
Do not use too much force when
tightening; Otherwise, it will cause
elbow fracture or rubber ring
deformation and leakage.
Note that the torque wrench must
be used to tighten with a torque of
10N.m. The maximum torque
cannot exceed 20N.m.
Rapid
Semi-rapid
1.75kW(127g/h)
1.30
/
0.87
/
/
1.00
/
0.66
1.30
1.00
0.87
0.66
/
1.00
/
0.66
1.30
1.00
0.87
0.66
Auxiliary
1.0kW(73g/h)
0.78
0.50
0.78
0.50
0.78
0.50
0.78
0.50
0.78
0.50
V.1
Publicidad
