Publicidad
Idiomas disponibles
Idiomas disponibles
5
Plug the power cord into
an electrical outlet.
6
Turn the cup upside down
and place it onto the Motor
Base, gently push and
twist.
14
7
Unlock the assembly
by gently pushing and
untwisting the cup
counterclockwise.
NOTE:
Blending should not require
longer than one minute to yield
smooth and creamy results.
CAUTION
Do not remove the Extractor Blade
from the nutribullet
®
Cup until blending
has completely ceased. Do not use the
Extractor Blade as a storage lid for your
cup. Some foods may contain active
ingredients or release gases that will
expand if left in a sealed container,
resulting in excessive pressure buildup
that can pose a risk of injury. When
storing contents in the cup, use plastic
wrap or foil to seal your container.
Always point contents away from your
body when unsealing.
Care & maintenance.
Cleaning the nutribullet
is easy,
®
simply place any of the pieces
(except for the Motor Base and
Extractor Blade) on the
TOP
RACK
of the dishwasher or hand
wash with warm soapy water
and rinse.
Here's how to clean
the nutribullet
:
®
STEP 1:
The most important
thing — ALWAYS UNPLUG
the Motor Base from the
power supply outlet when
it is left unattended, before
assembling, disassembling,
changing accessories or
approaching parts that move
in use or when cleaning.
Do not
attempt to handle the appliance
until all parts have stopped
moving!
STEP 2:
Remove the cup/Extractor Blade
assembly from the Motor Base.
STEP 3:
Clean the individual components
(Motor Base, Extractor Blades,
nutribullet
Cups) as follows:
®
MOTOR BASE:
• For the most part, the Motor
Base doesn't really get dirty,
but if you neglect to twist the
Extractor Blade on to the cup
tightly, liquids can leak out
and get into the base and
stick to the activator buttons.
• To avoid risk of injury,
NEVER
use your hands or utensils
to clean the white actuator
Tabs while the nutribullet
is
®
plugged in.
• Do not remove the rubber or
plastic liners inside the Motor
Base.
• Use a sponge or dish cloth
dampened with warm soapy
water to wipe down the inside
and outside of the Motor Base
until clean.
• Pay particular attention
to the white Actuator Tabs
on the inside of the Motor
Base to loosen any sticky
debris from drips and spills.
If necessary, you may use a
small brush to scrub the area
to ensure it is kept clean.
WARNING:
Never submerge
the Motor Base in water.
15
Publicidad
