Publicidad
Idiomas disponibles
Idiomas disponibles
be separated by pulling them apart. All accessories must be inserted
into the gun for proper use.
B, Align the lug on the top of the nozzle (10) with the lug insert on the top
of the lance extension (12). Push the adjustable fan nozzle onto the end
of the lance. A click will be heard when it clicks into place.
STEP 6
Connect the high pressure hose (6) to the water outlet of the pressure
washer. Insert and connect it quickly to avoid leakage. When the parts
are properly connected, the two components cannot be separated by
pulling directly on the water outlet. Press the "Button" according to
the direction of the arrow, then you can pull out the high pressure hose.
STEP 7
Connect the high pressure hose (6) to the gun (11). Insert and connect
it quickly to avoid leakage. When the parts are correctly connected, the
two components cannot be separated by pulling directly on the gun (11).
Press the gun lock button to remove the hose after use.
STEP 8
Connect the hose connector to the pressure washer. Before connecting
Instruction manual
the connector to the male connector, remove the plastic cap that is
inserted into the male connector of the pressure washer prior to
shipment. This plastic cap can be discarded once removed. Once both
components are installed, connect the Garden Hose with the Connector
Screw to the Pressure Washer. Connect the garden hose to the water
inlet.
STEP 9
If connected to a non-pressurised water supply, the water supply must
not be more than 50cm below the water inlet of the machine.
If the water source is at a higher elevation than the machine inlet, the
water surface must not exceed 50cm to the top of the water container. At
this point, the sprinkler cannot be installed. After starting the machine,
wait for the water to flow from the gun head and then connect the nozzle
for use.
It is important to ensure that the elevation of the water source is
adequate before installing and using the sprayer, and to follow this
procedure to avoid operational problems.
INSTRUCTIONS
START-UP
After connecting the pressure washer to the cold water supply, proceed
as follows:
▶Make sure that the ON/OFF switch is in the OFF position.
▶Connect the garden hose to the inlet connector.
▶Insert the adjustable spray nozzle into the gun according to assembly
21
step n 5.
ref. 08471
ES
PT
EN
FR
Publicidad
