ENVIRONMENT
If you need to replace your machine after prolonged use, do not throw
it in the household waste, but dispose of it in an environmentally safe
manner.
HOW TO TROUBLE
THE SWITCH IS IN THE "I" POSITION BUT THE MACHINE WILL
NOT START
▶The socket is defective.
Check the plug, socket and fuses.
▶The voltage is inadequate.
Check for proper voltage.
▶The power cable is not plugged in.
Connect the power cable.
PUMP DOES NOT REACH ADEQUATE PRESSURE OR
FLUCTUATES
▶Water inlet filter is clogged.
Remove and clean the filter
▶Pump is sucking air.
Tighten connections/purge system.
▶Suction valves are clogged/worn.
Clean or replace valves.
▶Garden hose diameter is too small.
Replace with 3/4" garden hose.
▶Water supply is restricted.
Check hose for kinks or leaks. The water supply tap is not fully open.
PRESSURE WASHER HAS OR WILL NOT HOLD PRESSURE
▶Excess air in water line and pump.
Turn off unit and water supply. Flush the system by holding down
the trigger.
PRESSURE WASHER IS MAKING EXCESSIVE NOISE
▶Intake is blocked.
Check intake valves.
▶Valves are worn, dirty or clogged.
Check, clean or replace valves.
▶Filter is dirty.
Check, clean or replace the filter.
ENGINE STOPS RUNNING WHILE IN USE
▶Net voltage lower than suggested.
Check for proper voltage.
EC DECLARATION OF CONFORMITY
We hereby declare that the design, construction and model of the device
comply with the health and safety standards and requirements of the
EU consistent policy.
Instruction manual
The declaration will be ineffective if the device is modified without our
approval.
Instrument type: Pressure washer 08471
ANWENDBAR EU GUIDELINES
▶EU Machinery Directive 2006/42/EC
▶EU Low Voltage Directive 2006/95/EC
▶EU Electromagnetic Compatibility Directive 2004/108/EC
▶EU Electromagnetic Compatibility Directive 2000/14/EC
▶EU Directive 2002/95/EC
HARMONISED STANDARDS APPLIED:
EN 60335-1:2012/A15:2021
EN 60335-2-79:2012
EN 55014-1:2021
EN 55014-2:2021
EN IEC 61000-3-2:2019/A1:2021
EN 61000-3-3:2013/A2:2021
EN 62233:2008
25
ref. 08471
ES
PT
EN
FR