Pur Line FRESH AIR 90 Manual De Instrucciones página 14

CONTROL PANEL
EN
Plug the appliance into a suitable socket.
1. ON/OFF
Press the ON/OFF button to turn the device on. It will turn on automatically
at the average air speed "M" and in the "Auto" mode. Press again to turn
off the device.
2. Air Quality Detection
This device has air quality sensors, which can detect the concentration
of dust particles in the air and the value will be displayed on the top of
the panel. The first 30 seconds after powering up the sensor is warming
up, meanwhile the display does not show any value, until the warm-up
is finished.
3. Speed selection
Press the SPEED button to select the required airflow.
- The default mode when the device is turned on is "Auto" mode.
- Press the "Speed" button to switch between low "L", medium "M", high "F",
"Sleep" and "Auto" modes.
- In "Sleep" mode, all indicator lights will be off except for the "Sleep"
indicator.
- In "Auto" mode, the device will automatically adjust the speed according
to the concentration of dust particles:
Particles concentration
< 75ug/m
75 ~ 150ug/m
< 150ug/m
4. Ionizer
Press the ION button to turn the negative ion function on or off, the
corresponding indicator turns on or off accordingly.
5. UV lamp
Press the UV button to turn the UV lamp function on or off, the
corresponding indicator turns on or off accordingly.
6. Timer
Press the TIMER button to set the timer, you can choose the operation
time from 1 hour to 24 hours, the selected operation time is shown on
the panel.
7. Filter replacement reminder
The device has a timing chip. After 3,000 hours of cumulative work, the
PM2.5's digital display will flash to remind you to change the filter.
After replacing the filter, press and hold the SPEED and TIMER buttons at
the same time for 5 seconds to reset the timer, the appliance will start the
next cumulative working cycle.
You can also press the RESET button on the remote control to restart.
8. Remote control
The device has a remote control. Check if you install the batteries correctly
when you first use it and make sure that the batteries are removed when
you do not use it for a long time.
12
Speed
Low
Mid
High