HIKOKI C 12RSH3 Instrucciones De Manejo página 23

GUARANTEE
We guarantee HiKOKI Power Tools in accordance with
statutory/country specific regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the Power Tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling
instruction, to a HiKOKI Authorized Service Center.
Information concerning airborne noise and vibration
The measured values were determined according to
EN62841 and declared in accordance with ISO 4871.
Measured A-weighted sound power level:
Measured A-weighted sound pressure level:
Uncertainty K: 3 dB (A).
Wear hearing protection.
Vibration total values (triax vector sum) determined
according to EN62841.
The typical weighted root mean square acceleration value
does not exceed 2.5 m/s
2
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one
tool with another.
They may also be used in a preliminary assessment of
exposure.
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the HiKOKI Authorized Service Center.
Symptom
Tool suddenly stopped
Cannot be tilted
Cannot be tilted to the right
Sawblade is dull
WARNING
○ The vibration and noise emission during actual use of
the power tool can differ from the declared total value
depending on the ways in which the tool is used
especially what kind of workpiece is processed; and
○ Identify safety measures to protect the operator that are
based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle in addition to the
trigger time).
Information for power supply system to be used with
101 dB (A)
electric tools provided with rated voltage 230 V~
88 dB (A)
Switching operations of electric apparatus cause voltage
fluctuations.
The operation of this electric tool under unfavorable mains
conditions can have adverse effects to the operation of
other electric apparatus.
With a mains impedance equal or less than 0.243 Ohms
there will probably be no negative effects.
Usually, the maximum permissible mains impedance will
not be exceeded when the branch to the power outlet is
fed from a junction box with a service capacity of 25
ampere or higher.
In case of power failure, or when the power plug is pulled
out, immediately return the switch to OFF position. This
prevents an uncontrolled restart.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
Possible cause
Tool was overburdened
The motor was automatically stopped
to prevent failure of the tool.
The bevel lock handle has not been
loosened.
Set pin (A) has not been pulled out.
The bevel lock handle has not been
loosened.
The sawblade is worn down or
missing teeth.
Bolt is loose.
23
Remedy
Get rid of the problem causing the
overburden.
This is not a malfunction.
The trigger switch was held down for
5 minutes or more.
Switch on the power once more.
Loosen the bevel lock handle and
then tilt the tool.
After adjusting the loosened
component, make sure to tighten it
once again.
Tilt to the right after pulling out set pin
(A).
Loosen the bevel lock handle and
then tilt.
Exchange with a new product.
Tighten the bolt.
English