neno Ivo Manual Del Usuario página 15

4 times. Pressing the button again will increase the magnification and the next one will restore the initial
state.
C. LULLABIES
While viewing the camera, press the "Lullabies" button on the monitor to switch them on. Pressing again
will turn the melodies off.
D. TWO-WAY COMMUNICATION
While viewing the camera, press and hold the "Two-way communication" button on the monitor while
speaking.
E. VOLUME SETTINGS
While viewing the camera, press the "OK" button and then use the up and down control buttons to adjust
the preferred volume. The current level is displayed in the lower left corner of the receiver.
F. DISPLAY BRIGHTNESS SETTINGS
While viewing the camera, press the "OK" button and then use the left and right control buttons to adjust
the preferred brightness. The current level is displayed in the lower right corner of the receiver.
G. MAIN MENU
Press the "MENU" button to enter the main menu, which contains 8 items:
• Camera
Press the "OK" button to proceed to pairing and disconnecting the camera.
If the camera is paired, you can disconnect it by holding the "OK" button for about 5 seconds.
If the camera is not connected to the receiver, press the "OK" button on the receiver and then press and
hold the pairing button for 5 seconds within 30 seconds.
• Feeding reminder
Press the 'OK' button to access the feeding reminder option.
Use the right and left control buttons to select the reminder frequency. Once selected, press the right
button until you get to the time, then set it using the down and up buttons.
After setting the time, press the "Menu and return" button to return to the Main Menu. The settings will
be saved automatically.
• Event alarm
Press the 'OK' button to access the alarm options.
Select the sensitivity of the cry alarms using the right and left control buttons and confirm the preferred
level using the 'OK' button.
Press the down control to select the sensitivity for motion detection and then the sensitivity level using
the right and left control buttons. Confirm the level using the "OK" button.
Press the down control and then select the alarm volume using the right and left control buttons.
Confirm the level using the "OK" button
Once set, press the 'Menu and Return' button to return to the Main Menu.
• Temperature and humidity alarm
Press the 'OK' button to access the alarm options.
Select the minimum temperature using the up and down control buttons. Then press the right control
button and similarly set the maximum sensitivity of the cry alarms using the right and left control
buttons and confirm the preferred level using the 'OK' button.
Then use the control button right left to select and set the minimum and maximum humidity at the
camera site analogously.
You can also select the temperature unit by confirming with the 'OK' button once selected. And you can
also disable the alarms completely.
Once set, press the 'Menu and Return' button to return to the Main Menu.
• Lullabies
Press the 'OK' button to access the alarm options.
Use the control buttons to select the lullaby you wish to play, the possible option to repeat or loop the
song, and the volume. Once selected, confirm each change with the "OK" button.
• Display settings
Press the 'OK' button to access the display setting options.
Use the right and left control buttons to select the screen refresh rate to reduce flicker or turn this
function off. Confirm the change with the "OK" button.
Press the control down to select the time after which the receiver enters sleep mode when inactive.
15