Suncast BMS6282 Instrucciones De Armado página 14

Assembly-Roof
Place roof on flat surface and lower support bracket (J)
into channel on under side of roof panel ( H). Support
bracket (J) top hole must be on the right side for proper
orientation. Align holes in truss leg to rockets on roof
panel. Attach bracket using ten screws ( HH).
Note: Support bracket must be installed in orientation shown
above. Roof will not fit if bracket is installed backwards.
0 0
0 0
0 ' 0 0
gee
... ` e
.
g " Ce?,
* e
h
e.
%
.0
e
e
P e tz.
i
e e c. e
ea.
e e
Lower roof bracket (L) into position on roof. Secure
bracket with easy bolt. Use easy bolt easy driver (FF)
to hand tighten. Easy bolt head will be flush when fully
seated. Do Not over tighten easy bolts.
Lower S- rail ( I) into position on roof ( H). Attach using
ten screws ( HH). S- bracket ( I) proper orientation is
shown above.
Note: There are no pre-drilled holes on the roof. Use force
when starting to drive self-tapping screws. Once the screw
pierces the plastic, it will drive easier.
14
Attach door clip brackets ( II) to bottom of roof panel ( H)
using two screws ( HH).
Note: The vertical portion of the bracket must be oriented
towards the inside of the shed.
14