Publicidad
Idiomas disponibles
Idiomas disponibles
Usage and LED indications
Self-leveling mode
Place the laser level in position making sure the pendulum lock switch is in the unlock position.
If the tool is out of self-leveling range the laser beam will blink at 2Hz until the tool is leveled, at
which point the laser level will stop blinking.
Manual Mode
This function is activated by placing the pendulum lock switch in the locked position, in this mode
you can use the laser level to project straight lines on any surface.
When deactivating the self-leveling function, the laser will blink every 5 seconds to warn that it is
working in manual mode and the leveling may not be exact.
LED power
Once the leveler is on and in self-leveling mode, hold the main button for 2 seconds, this will cause
the laser to blink 2 times and change the intensity of the laser.
If you always work with the maximum projection power, the laser will change to dim light when the
battery is low, at that time we recommend changing the 4 batteries and dont mix new batteries with
used ones this could affect the operation of the tool.
General instructions
To turn on your laser level, press the main button.
To turn the tool off, make sure that the lock switch
located on the right side of the laser is in the pendulum
lock position and keep the main button pressed until the
level stops projecting.
Publicidad
