Kerbl Connect BT 345130 Instrucciones De Uso página 12

CARE AND MAINTENANCE:
EN
Regularly wipe the ear cups, cushions and headband clean using a soft, damp cloth. Never use abrasive cleaning agents
or solvents.
Turn the ear cups facing outwards to dry if they are moist on the inside.
STORAGE AND TRANSPORTATION:
Always store the product in the original packaging and away from any sources of direct heat, sunlight and rain.
When stored ensure the headband is not stretched (applies to headband version) and the cushions are not compressed as
this may damage the product.
When transporting use original packaging, check packaging for further information.
CONTENTS:
EN
1 x Ear Muff, 1 x Micro USB Charging Cable, 1 x 3.5 mm Jack Male/Male Extension Cord, 1 x User Manual.
OPERATING INSTRUCTIONS:
CHARGING EARMUFF:
To comply with regulatory guidelines, your earmuff has been shipped to you with only a partial charge on its integrated
lithium ion battery pack. To charge the earmuff, insert the supplied micro-USB charging cable into the micro-USB jack
located on the bottom of the right cup of the earmuff. Connect the other end of the cable to a suitable USB power source
such as a computer or third party certified AC to USB wall adapter. The LED will be blink red while charging and goes out
when complete.
GETTING STARTED:
1. Press and hold the [Phone/On/Off] for 3 seconds to power on the earmuff. Voice assist will announce "Power ON"
and provide a battery status update such as "battery 80%".
2. Press and hold the [Volume +/Select Up] or [Volume -/Select Down] to adjust the volume.
3. Press and hold the [Phone/On/Off] for 3 seconds to power off the earmuff. Voice assist will announce "Turn Off".
LOW BATTERY WARNING:
Voice assist will provide a "Battery Low" warning every 3 minutes when battery voltage is low. Recharge the earmuff
at this time.
BLUETOOTH MODE:
®
1. Once powered on, the earmuff enter pairing mode with the LED blink red and blue alternately.
Make sure your BLUETOOTH
2. Check your BLUETOOTH
3. Once paired, the LED will turn blue and you will hear "Connected" from voice assist. The next time you power up,
your earmuff will automatically connect to your device and say "Connected".
4. Single press the [Phone/On/Off] to play/pause the music.
5. Single press the [Volume +/Select Up] or [Volume -/Select Down]
to skip forward/backwards between tracks.
6. Press and hold both [Volume +/Select Up] and
[Volume -/Select Down] 2 seconds to disconnect to current
BLUETOOTH device. You will hear "Disconnected" from voice
®
assist. The LED will turn red and blue blink alternately.
RECEIVING PHONE CALLS:
1. In BLUETOOTH
®
the music to be muted and you will hear "incoming call"
from voice assist until the call has ended.
To answer an incoming call, press [Phone/On/Off] once.
To disconnect from a call, press [Phone/On/Off] once
more.
2. To reject a call and return to BLUETOOTH
press and hold the [Phone/On/Off].
12
enabled device is scanning/searching for devices.
®
device and select "Kerbl Works Connetct BT 345130" to connect to the earmuff.
®
mode, incoming phone calls will cause
audio,
®
Micro USB
Charge Port
Power/Charging
indicator light
[Volume-/Select Down]
[Volume+/Select Up]
[Phone/On/Off]
Aux In