JVC RA-F223B Manual De Instrucciones página 42

Display
1. Volume level
2. Alarm 1 icon
3. Alarm 2 icon
4. DAB+ mode
CONNECTING TO POWER
1. Connect the cord of the power adapter to the DC IN jack of the radio.
2. Connect the plug of the power adapter to a wall socket.
The radio is powered and in standby mode when you see the display is switched on.
TURNING ON OR OFF
1. Press the POWER button in standby mode to turn the radio on.
2. Press the POWER button when the radio is turned on to switch it to standby mode. In standby
mode, the time is shown on the display.
To completely disconnect the radio from power, remove the plug of the power adapter from the wall
socket.
SETTING THE CLOCK
The date and time of the radio is automatically set once it receives radio broadcast signals (and
when such info is available). To set the date and time manually, see chapter "Time Setup" in "System
menu".
USING THE DISPLAY DIMMER
In standby mode, repeatedly press the DIMMER button to adjust the brightness (5 levels) of the
display.
LISTENING TO DAB+ BROADCASTS
1. Press the POWER button to turn the radio on.
2. Press the SOURCE button to select DAB+ mode. The DAB+ mode icon is shown on the display.
** Please note that the DAB+ radio signal can be much weakened depending on the type of terrain
you're driving in. For example buildings, hills, mountains etc. can make it difficult to get a good
DAB+ radio signal. Please check your local DAB+ radio provider to find out where you get the best
DAB+ radio signal coverage in your country.
5. FM mode
6. Sleep mode / Snooze mode
7. Signal strength
8. Time/Frequency/Message
EN-3