Toshiba Carrier RBC-AXU33UP-UL Manual De Funcionamiento página 10

6
HOW TO USE REMOTE CONTROLLER
■
Cooling/heating/fan only operation
Start
SWING
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool , Heat
3
Temperature button (
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of
MED , MED
+
• The OPERATION lamp on the display panel of
the indoor unit goes on. And operation starts after
approximately 3 minutes. (If you select FAN ONLY
mode, the unit will start immediately.)
• The : Fan only mode does not control temperature.
• Fan speed is the same as
HIGH .
Therefore, perform only steps
this mode.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with a cooling
only outdoor model outdoor unit,
remote controller but the heating operation is disabled.
9-EN
FAN
)
, or Fan only .
)
LOW , LOW ,
+
, HIGH
1 2 4
, and to select
)
appears on the
■
Dry operation
Start
1
START/STOP button (
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Dry
3
Temperature button (
Set the desired temperature.
• The fan speed display indicates
• The OPERATION lamp on the display panel
of the indoor unit lights, and operation starts after
approximately 3 minutes.
.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
- 9 -
Operations Manual
SWING FAN
)
.
)
.
)