Publicidad
Idiomas disponibles
Idiomas disponibles
15
QUIET button
Press this button to start quiet operation.
Pressing this button again will restore normal
operation.
■
Names and functions of indications
on wireless remote controller
Display
All indications, except for clock time indication, are
indicated by pressing the START/STOP
3
1
8
9
6
• In the illustration, all indications are indicated for
explanation.
During operation, only the relevant indications will be
indicated on the remote controller.
1
Transmission mark
This transmission mark (
remote controller transmits signals to the indoor
unit.
2
Mode display
Indicates the current operation mode.
(A : Auto,
: Cool,
: Fan only)
3
Temperature display
Indicates the temperature setting (62°F to 86°F
(17°C to 30°C)). When you set the operating mode
to
: Fan only, no temperature setting is indicated.
4
FAN speed display
Indicates the selected fan speed. AUTO or one of five
fan speed levels
(LOW
, LOW
, MED
+
MED
, HIGH
+
can be indicated. Indicates
operating mode is
5
TIMER and clock time display
The time set for timer operation or clock time is
indicated.
The present time is always indicated except for
TIMER operation.
button.
2
10
7
5
4
) indicates when the
: Dry,
: Heat,
,
)
when the
: Dry.
6
Hi POWER display
Indicates when the high power operation starts.
Press the Hi POWER button to start and press it
again to stop the operation.
7
P (PRESET) display
Indicated when memorizing the preferred
operation mode or when it has been memorized.
Also, this icon is indicated when the memorized
preferred operation is displayed.
8
(COMFORT SLEEP) display
Indicated during the OFF timer operation that
automatically adjusts the room temperature
and the fan speed. Each time you press the
COMFORT SLEEP button, the display changes in
the sequence of 1h, 3h, 5h, and 9h.
9
(QUIET) display
Indicated during the quiet operation.
10
Swing display
Indicated during the swinging operation where
the horizontal louver automatically moves up and
down.
NOTE
When both wired remote controller and wireless remote
controller are used, display on the screen of wireless
remote controller may differ from the actual operation in
some cases.
■
Preparation and check before use
1. Loading Batteries
• Remove the battery cover.
• Insert 2 new batteries
(R03 [AAA]) following the (+)
and (-) positions.
2. Removing Batteries
• Remove the battery cover.
• Remove the 2 used
batteries.
Batteries
• To replace the batteries, use two new batteries
(R03 [AAA]).
• In normal use, the batteries will last about one year.
• Replace the batteries if there is no receiving beep from
the indoor unit or when the air conditioner cannot be
operated using the remote controller.
• To avoid malfunctions by battery leakage, remove the
batteries when not using the remote controller for more
than one month.
• Please dispose of the used batteries according to the
local regulation.
- 4 -
Operations Manual
EN
4-EN
Publicidad
