Settings Menu - Hayward AquaRite AQR-PRO-75LSE Manual Del Usuario

Settings Menu

The Settings Menu is used to configure the AquaRite Pro LS and adjust various settings. Access this menu by pushing
the Settings Menu button. Refer to the information below when setting system operating parameters.
To access the Settings Menu
Setting
Press BOTH buttons SIMULTANEOUSLY for 5 seconds to unlock
Menu - Locked
Setting
Move to settings menus
Menu - Unlocked
NOTE: To prevent unauthorized access, the settings menu automatically "locks" after 2 minutes of no
buttons being pressed.
Rotates between available languages
Language
English Move to previous/next settings menu
Language
The AquaRite Pro LS can display the following languages: English (default), French, Spanish, Italian,
German, Portuguese and Dutch. Select the desired language.
Push to access Chlorinator option
Chlor. Config.
Move to previous/next menu item
+ to view/change
Toggle between Pool and Spa
Body of Water Type
Move to next menu item
Pools
Toggle between Salt (default) and Minerals
Display
Salt Move to next menu item
Toggle between available cell types
Cell Type
Move to previous/next menu item
T-CELL-15
Body of Water Type
Select Pool or Spa. "Pool" should be selected for bodies of water over 4 M³. The AquaRite Pro LS will
adjust its operation according to this selection.
Display
Allows for the display of salt (default) or mineral values.
Cell Type Selection
Ref. AquaRite Pro LS
AQR-PRO-75LSE
AQR-PRO-50LSE
Note that the unit will not function properly if the wrong cell is selected.
If AQL-CHEM is used
Push to access Chemistry Config. Wizard
Chemistry Config.
Wizard + to enter Move to previous/next menu item
Toggle between Enabled and Disabled (default)
Sensing System
Move to next menu item
Enabled
Requires use of the AQL-CHEM Sensing Kit. Following the steps of the Chemistry Config. Wizard will
set up the AQL-CHEM to sense ORP and pH levels. The AquaRite Pro LS will generate the correct
amount of chlorine to properly sanitize the pool based on the AQL-CHEM sensing function. Refer to the
AQL-CHEM manual for more detailed information.
If ORP Auto Sensing is not used
Adjust the desired output % for the pool
Chlorinator
Move to previous/next menu item
50%
The desired output % is used to control the amount of chlorine the AquaRite Pro LS generates. Raise
this setting to increase chlorine level and lower it to decrease chlorine level. If an AQL-CHEM is being
used and ORP Auto Sensing is enabled (see AQL-CHEM manual), the AquaRite Pro LS will override the
desired chlorinator output % setting and generate chlorine based on the pool's ORP level.
Page 9 of 16
T-Cell provided
T-CELL-LS15-E
T-CELL-LS9-E
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
AquaRite
Cell Type Selection in the menu
T-CELL-15
T-CELL-9
Pro LS
®
Rev. D