Hayward AquaRite AQR-PRO-75LSE Manual Del Usuario página 27

If ORP Auto Sensing is not used
Adjust Super Chlorinate period (1-96 hours)
Super Chlorinate
Move to previous/next menu item
22 hours
Use the Super Chlorinate feature when there is an unusually high bather load, a large amount of rain, a
cloudy water condition, or any other condition that requires a large amount of chlorine to be introduced
to the pool. Note that the filter pump must be running for the entire time during the Super Chlorinate
period. Set the actual time based on the size of the pool; larger pools require more hours, smaller pools
require less
If AQL-CHEM is used
Push to access pH Calibration Wizard
pH Calibration
Move to previous/next menu item
Wizard + to enter
Use this Wizard to calibrate the AQL-CHEM's pH probe. This requires a manual pH test of the pool
water using a dependable red phenol test kit (see AQL-CHEM manual).
If AQL-CHEM is used
Push to access Clean Probe Wizard
Clean Probe Wizard
Move to previous/next menu item
+ to enter
Use this Wizard to clean the AQL-CHEM's ORP and pH probes. The probes must be clean and free
from oil, chemical deposits and contamination to function properly. Slow response, increased need to
calibrate, and inconsistent readings are indications that the probes need to be cleaned (see AQL-CHEM
manual).
Toggle between Metric and English
Units
Move to previous/next menu item
Metric
The AquaRite Pro LS can display temperature and units in Metric (ºC and g/L) or English (ºF and PPM).
Make the desired selection here.
Toggle between Always On and On for 60 sec.
Display Light
Move to previous/next menu item
On for 60 sec
This function controls the backlight on the display. Select between "Always On" and "On for 60 seconds".
If "On for 60 seconds" option is selected, then the backlight will automatically turn off 60 seconds after
the last key is pressed and will stay off until next time a key is pressed.
Toggle between Enabled (default) and Disabled Beeper
Beeper
Enabled Move to previous/next menu item
When "Enabled", the keypad will beep every time a key is pressed. If this audible indication is not
desired, select "Disabled".
Initiate reset of all configuration parameters
Reset Config. to
Default Press + Move to previous/next menu item (config. not reset)
Reset all configuration parameters
Are you sure?
+ to proceed Move to previous/next menu item (config. not reset)
Config. reset
Move to previous/next menu item
Confirmed
Use this function to erase all previous system configuration and reset all configuration parameters back
to the factory default values.
This function is NOT reversible, be careful
Assuming that the water chemical levels are in the recommended range, there are three factors that you can control
which directly contribute to the amount of chlorine the AquaRite Pro LS will generate:
1. filter run time each day (hours)
2. the desired output % setting or ORP setting (when using AQL-CHEM)
3. the amount of salt in the pool
The filter pump timer should be set so that entire volume of pool water passes through the filter each day. For pools with
high chlorine demand, the timer may have to be set longer to generate enough chlorine.
Page 10 of 16
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
AquaRite
OPERATION
Pro LS
®
Rev. D