Publicidad
Idiomas disponibles
Idiomas disponibles
Caring for the Blender
Troubleshooting Guide
Problem . . .
Blender fails to start
or stops while it is
running and cannot
be restarted
Ingredients will not mix
properly
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily
Unplug the blender, remove the container from the base, and then inspect the container
and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if necessary.
If the blades are loose, discontinue use immediately and replace the blades.
Do not attempt to repair or tighten the cutter assembly. See "Replacement Parts" below.
Weekly
Unplug the blender, and then inspect the power cord insulation and power plug for cracks.
Refer to "Technical Service" on page 2 for repair or replacement.
Quarterly
Replace the container and cutter assembly at least every 90 days. See "Replacement
Parts" below.
Replacement Parts for Models HBH908 and HBH909
For replacement parts, call toll-free: 866-285-1087.
Part Description
44-oz. polycarbonate container
32-oz. stainless steel container
Cutter assembly
Solution . . .
• Check to see if unit is securely plugged into an electric outlet.
• Check to see if the fuse for the electric outlet has blown or if a circuit breaker
has tripped.
• Check to see if enough liquid has been added to the ingredients. Mixture should
be fluid and free-running at all times.
• Solid pieces are too large. Pieces should not exceed 1" (25-mm) cubes.
• Container is too full. Do not fill past highest graduation marking.
• Cutter unit blades are not sharp or are damaged. Inspect container and cutter
assembly daily. Replace cutter assembly at least every 90 days or sooner if cutter
assembly appears worn or damaged.
• Check to see if cutter assembly is installed properly.
• Select speed to create a fluid blend.
Part Number
6126-HBB908
6126-HBB909
98908
9
Publicidad
