Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Diagram
POWER
CHECK
1.Please choose a flat wall for installation,and avoid installing in places where it is easy to touch people
and doors;
2.When installing, the air outlet should be more than 40 cm away from the countertop . If there is no
countertop under the hand dryer, please refer to the installation height on the right;
3.Do not have a mirror near the right side of the unit, as water droplets may splash when drying your
hands. (more than 100 mm apart);
4.Please use 1mm²~1.5mm² power cord.
Precautions Before Installation
1.Before installation, please make sure that there are no obstacles
within 40 cm below the sensor to ensure that the machine will not
malfunction;
2.Do not install the hand dryer on a wooden or plastic wall, otherwise
there is a danger of the machine falling;
3.Before installation, please make sure that the power supply used
Warning
is in line with the specifications of the hand dryer;
4.Do not perform installation construction while the product (power
cord) is powered on;
5.Wear gloves when installing, otherwise there is a risk of injury.
EN
Metal Mounting
Plate
Safety screw hole
Hollow wall anchor hole
Junction Box
5
Please do not install in the following places (otherwise it may malfunction)
1.Places with corrosive, oxidizing and reducing gases;
2.Places prone to condensation;
3.Places beyond 0~2000m above sea level;
4.Places with direct sunlight and strong light;
5.Places that can be directly exposed to water.
Installation Notes
①
Power cable
Hollow wall anchor hole
Connection construction.
When installing the hand dryer without a
junction box, you need to install a standard
socket corresponding to the hand dryer on
the upper right side of the hand dryer, with
a distance of 20-50 cm. (If you need to
connect the power cord directly, please
insert a coverless junction box at the
installation location. If the junction box is
not used, the power cord will be squeezed
out of the body and affect the installation.)
EN
②
Metal Mounting Plate
Power cable
Safety screw hole
Placing the Metal Mounting Plate.
Stick the mounting plate on the wall at a
proper position, use a drill to drill holes in
the designated positions, then insert the
hollow wall anchors into the drilled holes,
and pull out the power cord to connect
with the power cord of the hand dryer.
When connecting the wires, the brown
wire must be connected to the live wire,
and the blue wire must be connected to
the
neutral
wire,
and
wrapped
insulating tape to ensure no leakage.
6
with
Publicidad
