Publicidad
Idiomas disponibles
Idiomas disponibles
EN: MEAT GRINDER WITH TOMATO JUICER | Instruction Manual
1.prese the release button
1. Assemble the ream meat rod, blade, blade disk and lock nut as illustrated as figure (see fig.2) before ream meat tube, and
the appliance can be used now.
NOTE: Make sure the edge of blade toward the blade disk when assembling. Never assemble the blade reversely.
CAUTION: Make sure the appliance is unplugged when assembling.
2. Put the funnel on the ream meat tube.
3. Ensure that the rocker switch is set at "O" position, then plug in power supply.
4. Press the rocker switch to "ON" position (the ream meat rod and the blade turns anti-clockwise), when the appliance
operates normally, put the meat piece into funnel, then press the food pusher to the lowest position.
NOTE: Cut all foods into pieces (Sinewless, boneless, and fatless meat is recommended, approximate size :20 mm x 20 mm x 60
mm) so that they fit easily into the hopper opening.
5. The max operation time per time shall not exceed 7 minutes and minimum 30 minutes rest time must be maintained
between two consecutive cycles.
6. Place a clean container with proper size under lock nut to receive meat powder come from the appliance.
7. When finish blending, unplug to the power source, Disassemble the ream meat tube assembly: press down release button
properly with thumb of left hand (see arrow 1 of Fig.3), turn the ream meat tube assembly clockwise with right hand then
remove them (see arrow 2 of fig.3).
Fig.1
Fig.2
5
Publicidad
