Publicidad
FOR US ONLY:
FCC Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer ence in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guar antee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
To assure continued compliance, follow the attached installation instructions and use only shielded inter face
cables with ferrite core when connecting to com put er or peripheral devices. Any changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to operate this
equipment.
Trade Name:
Type No.
Responsible party/
Support contact:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Contains FCC ID: N5A4062
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This
equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the
FCC radio frequency (RF) Exposure Guidelines.
Complies with 21 CFR 1040.10 and 1040.11 except for conformance with IEC 60825-1 Ed. 3., as described in
Laser Notice No. 56, dated May 8, 2019.
FOR CANADA ONLY:
CAN ICES-003 (B)/NMB-003(B)
IC: 11245A-4062
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device. This equipment has very low levels of RF energy that are deemed to comply
without testing of specific absorption ratio (SAR).
FOR SINGAPORE ONLY
Complies with
IMDA Standards
DA106734
LEICA
4062
Leica Camera Inc.
500 Frank W. Burr Blvd., Suite 570,
Teaneck, NJ 07666
Tel.: +1 800 222 0118
Country of Origin:
Made in Portugal
Type No.: 4062
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
Publicidad
