Descargar Imprimir esta página

Champion cooler MasterCool MCP44 Manual De Instalación Y Funcionamiento página 5

Enfriador evaporativo de ventana

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION PROCEDURES (
See page 3 for instructions on unpacking and securing the
fan housing.
Installation in Window
NOTE: We recommend two people for installation.
1. Remove screen (as needed) and make sure window is opened
to its maximum height. From the exterior of the window, slide the
fan assembly section into the window. Have the person on the
interior adjust the exact placement of the unit for aesthetics and
correct lengths of the two accordion spacers (included).
Note: After identifying the position for installation, place
a bubble level on the top of the exterior back of the unit
and make adjustments to ensure the unit will be level when
installation is complete. It is recommended to verify unit is
level at various points during installation.
Exterior
2. Closing the window may help hold the unit in place during the
following steps.
Push the unit into the window until the fan assembly
is fully in the window opening. The lip of the fan assembly should
be positioned outside the window. The width of the lip will typically
require a spacer (not supplied) to be used at the bottom of the cooler
to ensure a square installation. Use two (2) masonry screws (ITEM
D) or other fasteners to secure the unit to the exterior structure.
Interior
3. Four L-brackets (ITEM G) are supplied to secure the cooler to
the window structure. Recommended installation is using two
brackets to secure unit at the top and two securing it to the win-
dow sill. However, you may configure your installation as needed
as long there are four secure attach points.
NOTE: For easy installation, there are grooves in the
bottom of the fan housing that fit the brackets.
4. Verify that assembly is secure to prevent vibration between the
front and back sections.
5. Attach accordion closeout panels (ITEM J) by peeling off the
adhesive strips and attaching one side to the window casing and
one side to the fan assembly. Short screws (not included) can
be used for a more secure installation. (Make sure screws do
not interfere with fan blade.)
6. Once accordion spacers are installed, seal any gaps around
the spacers with silicone or all weather caulk (not supplied).
Installation in Wall
1.
This cooler is approved for in-wall installation. Contact a licensed
contractor to have the cooler installed in an outside wall.
33
5
/
5
21
/
5
"
21
/
8
"
46
1
/
8
FRONT VIEW
see illustrations at right)
"
8
"
8
3
"
9
/
4
"
" 10
5
/
12
3
/
16
8
ITEM C
EXTEND
(12 PLACES)
FULLY
Exterior View
BRACKET INSTALLATION
POSSIBLE BRACKET
LOCATIONS
WINDOW SCREW
WINDOW SILL
4" MINIMUM
"
5
33
/
8
"
13
19
/
16
SCREWS
5
"
21
/
8
SPACER TO ENSURE
FLUSH/SQUARE
INSTALLATION
(NOT SUPPLIED)
TOP VIEW
5
NOTE
WIDTH
OF FAN
ASSEMBLY LIP
FASTEN TO EXTERIOR
SIDING WITH
MASONRY SCREW
ITEM D
SPACER TO ENSURE
SQUARE INSTALLATION
Interior View
WINDOW
WINDOW SILL
OPTIONAL MOUNTING
TRACKS FOR BRACKETS
SCREWS
BRACKET
LOCATIONS
UNDERSIDE OF FAN HOUSING
SCREW
SCREWS
SILL BRACKET
SILL PLATE
4"
MINIMUM
SCREWS
ITEM B
BRACKET
ITEM A

Publicidad

loading

Este manual también es adecuado para:

Mastercool mcp44cMastercool mcp59