Publicidad
Idiomas disponibles
Idiomas disponibles
English
Unpacking Your Washer
• Remove all packing materials. This includes the foam base and all
adhesive tape holding the washer accessories inside and outside.
• To remove the cardboard shipping brace from the washer, step on the
cardboard base and tilt the washer back, until the security shipping
screw is free from the base. Slide out the cardboard base and lower the
washer in place. Open the top lid to remove the styrofoam drum brace.
Pull to remove.
Note: Save both the shipping and drum brace. Reinstall when moving the washer.
• Inspect and remove any remains of packing, tape or printed
materials before using the washer.
Leveling Your Washer
• Your washer has 4 leveling legs; which are located on the four bottom
corners. After properly placing your washer in its final position, you can
level your washer.
• Leveling legs can be adjusted by turning them counterclockwise to raise
your washer or turning them counter clockwise to lower your washer.
15
Publicidad
