Leckey Horizon Manual Del Usuario página 12

8.10 Positioning
Flexible Hip Laterals
The Flexible Laterals can be used as an
alternative to the pelvic band. The Laterals
can be individually adjusted in width as well
as in height. To adjust the width loosen the
knob (a) on the back of the hip pad, then
adjust the flexible laterals to the required
position and finally re-tighten the knobs.
For the height positioning of the Laterals
loosen the allen bolt (b), position the Lateral
as required and then re-tighten the bolts
securely. The flexible Laterals supports are
secured around the user by tightening the
safety strap into position. Fasten the safety
strap immediately.
Check the laterals are secure before
placing the user in the product. As if
they are loose the user may be at risk
of slipping out of the product and could
cause them serious injury.
A
B
8.11 Activity Tray
Adjustment – Supine
The Tray is attached to and removed from
the frame by the metal brackets located
below the chest pad. To attach the tray
slide the metal bars into the receiving
tubes to the required depth and secure
by tightening the knobs (a) on either side.
There are limit poppers in the end of the
tray tubes to show the maximum depth
adjustment allowed. These may need to be
depressed to
remove the tray.
To adjust the height loosen the four knobs
(b), set the tray to the required position and
then retighten the knobs securely.
B
The tray angle can be adjusted by
loosening the plastic handle (c) on either
side of the tray, set the tray to the required
angle and tighten the plastic handles again
securely.
A
B C