Leckey Horizon Manual Del Usuario página 13

8.12 Activity Tray
Adjustment – Prone
To lock the tray and set its height push the
locking lever (a) down until it touches the
metal spine. After use this may need to
be fine tuned to ensure secure locking. To
do this lift up the lever and turn the nut (b)
while holding the lever in a fixed position.
Push the lever back down to check if it
locks the tube securely. Repeat the process
as necessary.
The tray angle can be adjusted by
loosening the ratchet handle on either side
of the tray, set the tray to the required
angle and tighten the plastic handles again
securely.
A
B
Always use caution when making this
adjustment, as fingers could become
trapped in the slot while positioning.
Always use caution when inserting the
tray to make sure the child's hands or
arms do not become trapped.
Do not place hot objects on the tray,
not greater than 40 degrees Celsius.
Please note that the tray is for the use
of the user only. Do not lean or place
heavy objects on the tray, not greater
than 8kgs (17.6lbs).
Never use the tray to steer or push
the stander.
Do not height adjust the headsupport
beyond the hazard strip at the end of
the tube.
Always use caution when making this
adjustment, as fingers could become
trapped in the receiving tube while
positioning.
8.13 Head Support
Adjustment - Supine
The head support can be adjusted in
depth, height and angle. To height adjust,
unlock the lever (a) at the top of the central
spine, position to the desired height and
then re-lock.
For fine height, depth and angle adjustment
loosen the two knobs (b), one on either
side of the square tube, position the head
support and then re-tighten securely.
In addition to this, the contoured headrest
can be adjusted laterally. Loosen the screw
on top of the contoured headrest bar (c).
Adjust to the position required and
retighten screw.
A
C
B