MESTIC SMART ADVENTURE Instrucciones De Uso página 28

Power saving mode:
1. Users can activate the power-saving mode and set the PSI/PSO value. (The minimum power level
is 1VA.)
2. When the actual load power is lower than the PSI (the power to enter the power-saving mode),
the system will automatically switch to the power-saving mode. In this mode, the device output is
turned on for 1s and then turned off for 5s.
3. If the actual load power exceeds the PSO (the power to exit the power-saving mode), the inverter
will automatically exit the power-saving mode and resume normal operation.
Enable power saving mode (PSE):
1. In the real-time interface (the default interface after the device is powered on) of the remote
meter, press and hold the
2. Press the
3. Press and hold the
4. Press the
5. Select ON to enable the power saving mode.
6. Select OFF to disable the power saving mode.
7. Press and hold the
Set the power to exit the power saving mode (PSO):
1. In the parameters setting interface, press the
2. Press and hold the
button to enter the parameters setting interface.
or button to select the PSE parameter.
button until the PSE parameter (OFF default) flashes.
or button to set the PSE state.
button to confirm.
button until the PSO value flashes.
or button to select the PSO parameter.