Publicidad
English
Scenario 1:
CCTV surveillance or point
to point data transmission
1. Set up the CPEs (AP mode + Client mode)
Tips
-
At least two CPEs are required for bridging. One CPE can bridge with 15
CPEs at most.
-
Automatic bridging only works for CPEs in factory settings.
Place two CPEs in factory settings next to each other, open
their covers and power them on.
After the CPEs complete startup, they start automatic
bridging and their LED1, LED2 and LED3 indicators blink
quickly. About 1 minute later, when the LED1, LED2 and LED3
indicators of one CPE light solid on and those of the other
CPE blinks slowly, the automatic bridging succeeds.
To bridge more CPEs, put other CPEs in factory settings near
the CPE working in AP mode (LED1, LED2 and LED3 are solid
on), and power them on one by one within 30 minutes.
Power
PoE / LAN1
LAN2
LAN3
LAN4
CPE1: AP mode
LED1, LED2 and LED3
are solid on.
LED1
LED2
LED3
Example: OS3 (Peer-to-multiple bridging)
CPE2: Client mode
LED1, LED2 and LED3
are blinking.
Power
PoE / LAN1
LAN2
LAN3
LAN4
LED1
LED2
LED3
CPE16: Client mode
LED1, LED2 and LED3
are blinking.
Power
PoE / LAN1
LAN2
LAN3
LAN4
LED1
LED2
LED3
02
Publicidad
