Bosch HMV8052U Manual De Instrucciones página 7

Appliance dimensions
Electrical Installation
Electrical Requirements:
a three prong grounded outlet
▯
120 V, 60 Hz, AC only
▯
20 Amp electrical supply with a fuse or a circuit
▯
breaker
This product must be connected to a supply circuit of the
proper voltage and frequency. Wire size must conform to
the requirements of the National Electric Code or the
prevailing local code for this rating. The power supply
cord and plug should be brought to a separate 20-amp
branch circuit single grounded outlet. The outlet box
should be located inside the cabinet above the appliance
(see section Location Requirements). The outlet box and
supply circuit should be installed by a qualified
electrician and conform to the National Electrical Code or
the prevailing local code.
The voltage used must be the same as specified on this
microwave oven. Using a higher voltage is dangerous
and may result in a fire or oven damage. Using a lower
voltage will cause slow cooking. The manufacturer is not
responsible for any damages resulting from the use of
the oven with any voltage other than specified.
Note: Take into account that the front and rear
measurements of the appliance are not identical.
Power Requirements
The outlet must be properly grounded in accordance with
all applicable codes.
It can be installed anywhere inside the cabinet above the
appliance, within reach of the power cord (approx. 24 in).
7