Publicidad
Idiomas disponibles
Idiomas disponibles
Test the location for the baby unit
If you plan to install your baby unit in a designated
location, and use your home Wi-Fi network to
connect your video monitor, you need to test
which of your selected monitoring areas within
the house have good Wi-Fi signal strength. After
you have powered on your Parent Unit, you can
use your Parent Unit Wi-Fi signal strength indicator
to assist in checking. Once you have identified the
suitable location, you can install your baby unit.
Adjust the distance between your baby unit and
the Wi-Fi router if needed.
• Depending on surroundings and obstructing factors,
such as the effect distance and internal walls have on
signal strength, you may experience reduced Wi-Fi
signal. To improve the Wi-Fi signal strength, adjust
the distance or direction of your Parent Unit. Check
with your Parent Unit again.
Auto software and firmware update
To ensure that your HD video monitor is always at its best performance, the parent
unit will prompt a message and ask you to update its software and the baby unit's
firmware when there are new versions available. Select "Now" to reboot the system,
or switch off and on the parent unit later to reboot the system into the latest software.
• To check if your device is running on the latest software, or to update your device
software, go to:
>
> Software Update.
Connect your HD video monitor with home Wi-Fi network
• You must connect your video monitor to your secured home Wi-Fi network in or-
der to receive the latest software and firmware updates. To set the Wi-Fi up, go to:
>
> Configure Wi-Fi.
Note
• Make sure the baby unit is on when you set up the Wi-Fi network.
18
mount the baby unit (optional)
Notes
NOTES
NOTE
• Check for reception strength and cam-
era angle of the baby unit before drilling
the holes.
• The types of screws and anchors you
need depend on the composition of
the wall. You may need to purchase the
screws and anchors separately to mount
your baby units.
2. If you drill the holes into a stud, go
to step 3.
•
If you drill the holes into an object
other than a stud, insert the wall
anchors into the holes. Tap gently
on the ends with a hammer until
the wall anchors are flush with the
wall.
3. Align the wall mount bracket and screws with the
holes in the wall as shown. Tighten the screw in the
middle hole first, so that the wall mount bracket
position is fixed. You can tighten the other screw in
the top hole.
4. Place the baby unit on the wall mount bracket,
and then slide it forward until it locks into place.
Connect the power adapter to the baby unit and a
power supply.
1. Place the wall mount
bracket on a wall
and then use a pen-
cil to mark two holes
in parallel. Remove
the wall mount
bracket and drill
two holes in the wall
(5.5mm drill bit).
19
Publicidad
