Publicidad
Idiomas disponibles
Idiomas disponibles
Charge the parent unit battery before use
The parent unit runs on rechargeable battery or AC power. To continuously monitor your
baby, keep the parent unit connected to AC power.
• Before using the baby monitor for the first time, charge the parent unit battery for 12 hours. When
the parent unit battery is fully charged, the battery icon
• The standby time varies depending on your actual use.
The parent unit turns on automatically after connecting to the power socket, and the
welcome screen appears. You can press
hold to turn it off.
The battery icon indicates the battery status (see the following table).
Battery indicators
Battery status
The battery has very little
and
are displayed on
charge and may be
the parent unit screen, with the
for only a short time.
LED light flashes.
The battery icon segments are
The battery is fully charged. To keep the battery charged,
solid
.
Raise the parent unit
antenna for better
reception
segments are
solid
.
Power to turn the parent unit on or press and
Action
Charge without interruption
used
(about 30 minutes).
connect it to AC power when
in use.
8
Test the sound level and position the
baby monitor
Testing the sound level of the baby monitor
• This baby monitor is intended as an aid. It is not a substitute for proper adult supervision, and should
not be used as such.
• For hearing protection, make sure the parent unit is more than 1 metre away from the baby
unit. If you hear any feedback noise from the parent unit, move the parent unit further until
the noise stops. You can also press
on the parent unit to lower or mute the noise.
• Increase the parent unit speaker volume if you cannot hear the sounds transmitted from the baby unit.
> 3m
Positioning the baby monitor
• Keep the baby unit out of the reach of your baby. Never place or mount the baby unit inside the baby's
cot or playpen.
1. Place the baby unit more than 1 metre away from
your baby.
9
Publicidad
