Melchioni Family SUN Manual De Instrucciones página 17


The appliance must not be stored or used in excessively humid or dusty
environments, in the presence of atmospheres saturated with gas, fumes, in excessive
or low temperatures or under direct solar radiation.

The appliance must not be used in explosive atmospheres, near explosive,
combustible, detonating or flammable material (e.g. petrol pumps, gas cylinders, etc.).
Such use constitutes a serious risk to the safety of the operator and persons nearby
and may cause fires or deflagrations.

Make sure that each part of the appliance, especially the cord, is placed at a safe
distance from heat sources (e.g. electric or gas cookers), both during use and when
not in use.

The appliance and all its parts must be handled with special care to avoid
damaging the halogen lamp, which is particularly fragile.

During use, the appliance must be constantly supervised: do not use it in the
absence of operators or persons who are able to constantly check its correct
operation.

If the appliance needs to be left unattended, switch it off.

During use, the appliance must be placed at a minimum distance of 20 cm from
surrounding objects on each side: this precaution prevents parts from overheating and
improves performance.

The appliance must be placed in a location where its operation cannot cause
overheating, deformations or the unexpected movement of objects and materials.
Therefore, check the trajectory of the outbound air flow.

Do not use the appliance to dry garments or any other objects by resting them on
the grille, which would seriously compromise the integrity of the appliance, as well as
the health and safety of the operator and nearby persons and animals.

Do not insert any objects into the grille: damage to the mobile parts or lamp could
create situations of risk for the user and nearby persons and animals through injury or
electric shock.

Take the utmost care not to touch any part of the appliance during operation or
in the minutes immediately following operation: parts reach temperatures capable of
causing burns and physical injury.

Ensure a standstill period of at least 30 minutes every 60 minutes of use in heating
mode.

Do not surround the appliance with any heat reflective material (e.g. aluminium).
Doing so in no way enhances its performance and causes overheating, with the
possibility of breakdowns and danger to the operator and nearby persons or animals.

Make sure that every part of the appliance has cooled down adequately before
storing it.
16