Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the solar cell
Make sure that you will not drill into electrical, gas or water lines in-
side the wall. Use a power drill to drill holes into brick walls. Always
observe all safety instructions in the power drill manual. Death or in-
jury due to electric shock may otherwise result.
The solar cell
cell surface will be directed to the south. The enclosed bracket
ensure the solar cell
Mount the bracket
enclosed screws
(ø 6 mm) (see Fig. C).
Note: The enclosed mounting material is suitable for ordinary masonry
construction. Other wall substrates may require other fastening materials.
Seek specialist advice when in doubt.
After mounting, verify the solar cell
Then attach the solar cell
Next adjust the solar cell
After mounting the two operating units (main unit
the connection cable so it is not subjected to mechanical stress. Use typical
installation material such as cable clamps or conduit to fasten the connection
cable, to prevent damage to the insulation.
Start-up
Note:
The solar cell
detector
only responds to movement.
3
When selecting the setup location for the solar cell
solar cell
4
sources, e.g. street lighting.
28 GB/IE
requires direct sunlight when possible. Ideally, the solar
4
is mounted horizontally.
4
of the solar cell
8
(4 x 30 mm) and the enclosed wall plugs
6
as shown in Fig. C.
4
to face south.
4
also works as a twilight sensor, while the motion
4
just as the twilight sensor is not affected by other light
to a vertical wall using the
4
is fitted securely by the bracket
4
and solar cell
1
will
8
7
8
) run
4
be sure the
4
.
Publicidad
