Publicidad
Idiomas disponibles
Idiomas disponibles
This product does not contain any parts that can be serviced by the
user. The LEDs are not replaceable.
The light's illuminant is not replaceable. The entire light needs to be re-
placed if the illuminant reaches the end of its service life.
Never electrically connect the product to other string lights.
Never connect the product directly to a 230 V supply.
The battery compartment is protected against foreign matter and spray
water according to IP44. Never allow the battery compartment to be
exposed to rain or direct jets of water.
Set-up
Installing LED light sticks in the ground
WEAR SAFETY GLOVES! Wear safety gloves when in-
stalling the LED light sticks
sticks
Push the ground stakes
bed) so that they are firm in the ground.
Make sure they are firmly positioned. Do not use excessive force, e.g.
strike with a hammer, when you are pushing the ground stakes
the ground. This will damage the product.
STUMBLING HAZARD! Ensure that the supply lead is laid in such
a way that no one can walk on or stumble over it.
RISK OF INJURY! Make sure that when the LED light sticks
removed, the ground stakes
pose any risk (e.g. stumbling over them).
Inserting/replacing batteries
Open the battery compartment
it (see Fig. B).
Insert batteries or replace the old batteries with new ones. Please note
the polarity when inserting the battery. This is indicated in the battery
compartment
2
"Technical data").
Close the battery compartment
latches again. Pay attention to the sealing ring when doing this, as
otherwise IP protection cannot be guaranteed.
Switching the LED light sticks on/off
Press the TIMER/ON/OFF button
follows:
24 GB/IE
if the ground is frozen.
1
far enough into the ground (lawn, flower
4
are also removed, so that they cannot
4
. Only use batteries of the recommended type (see
2
. Do not install the LED light
1
by loosening the latches and open
2
by snapping it shut and snap in the
to change the lighting modes as
3
into
4
are
1
Publicidad
