Publicidad
Idiomas disponibles
Idiomas disponibles
All four corners of the saw must be bolted to the tool mounts
before use. Make sure bolts do not extend above the table of the
miter saw.
1. Unplug the saw and lock the saw arm in the down position.
2. Place a tool mount underneath the saw, aligning the mounting
holes on the miter saw base with the slot in the top of the tool
mount.
3. Feed a carriage bolt up through both the tool mount and a
mounting hole in the saw.
4. Secure in place using a flat washer, lock washer and nut.
5. Repeat through the other end of the tool mount.
6. Place the second tool mount underneath the other side of the
saw, aligning the mounting
holes on the miter saw
base with the opening in
the tool mount.
7. Install carriage bolts
as previously described.
8. After making sure
both tool mounts are
parallel to each other,
tighten all four nuts to
hold in position.
12
Nut M8
Spring
Washer φ8
Washer φ8
Bolt M8*60
MOUNTING THE MITER SAW TO THE STAND
Figure 5
Use the handles located at the rear of the tool mounts to aid in
installing or removing saw and tool mount assembly.
1. Lift the saw and tool mount assembly, allowing the assembly to
tilt slightly toward your body.
2. While still toward you, hook the front edge of the tool mount
assembly onto the front rail of the stand.
3. Lower the tool mount assembly to allow the rear edge of the
tool mount to seat fully over the rear rail.
4. Lock the tool mounts in position by lowering the locking levers.
NOTE: Continue to hold the tool mount assembly with one
hand until both levers are securely locked.
1. Check position and adjust, if necessary, to make sure the
weight of the saw is evenly balanced
over the rails.
2. Ensure the saw is fully seated and
locked in position, then securely
tighten the four nuts holding the saw
to the tool
mount.
13
Publicidad
