Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
BRACKET ADJUSTMENT SCREW
Most plastic tool mounts are designed to fit snugly over the stand
rails. With the locking levers in the lowered (locked) position, you
should not be able to remove the saw and tool mount assembly
from the rails. If the saw and tool mount can be removed from the
rails when the levers are locked, the tool mount adjustment
screws need to be tightened. If the saw and tool mount will not fit
over both rails, the tool mount adjustment screws needs to be
loosened.
NOTE: The saw should be removed from the tool mounts
before attempting to tighten or loosen the tool mount
adjustment screws.
16
Work
Support/Stop
Adjustment
Knob
TO ADJUST
Figure 8
1. Use a wrench to slightly loosen the nut.
2. Turn the screw with a Phillips screwdriver. Rotate clockwise if
the tool mount assembly needs to be tightened or
counterclockwise if the assembly needs to be loosened.
3. Install the tool mount on the miter stand rails and lower the
locking lever to check the adjustment.
4. When the correct position is achieved, wrench tighten the nut
to secure.
5. Repeat with the second tool mount.
6. When adjusting the handle, press the adjusting button to fix
and relax the function.
Adjust the button
Nut
Tool Mount
Adjustment Screw
Tool Mount
Wrench
17
Publicidad
