Function Settings - Kenwood KDC-MP102U Manual De Instrucciones

Reproductor de discos compactos receptor de fm/am
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Function settings

1 To enter [AUD CTRL] menu (see table below): Press AUDIO.
To enter [SETTINGS] menu (page 11): Press the volume knob to enter [FUNCTION]
mode. Turn the volume knob to select [SETTINGS], then press to enter.
2 Turn the volume knob to make a selection, then press to confirm.
See table below for selection.
Repeat this step until the desired item is selected/activated.
Press
to return to the previous item.
3 Hold
to finish the procedure.
[AUD CTRL] : While listening to any source except in STANDBY state...
Item
SW LEVEL
SW L –15 — SW L +15 (Preset: SW L 0): Adjusts the subwoofer output level.
BASS LVL
–8 — +8 (Preset: 0): Source tone memory: Adjusts the level to memorize in each source. (Before making an
adjustment, select the source you want to adjust.)
MID LVL
TRE LVL
EQ
NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects a preset sound mode suitable to
the music genre. (Selects [USER] to use the customized bass, middle, and treble settings.)
B.BOOST
BB-L LV1/ BB-L LV2/ BB-L LV3: Selects your preferred bass boost level. ; BB-L OFF *: Cancels.
LOUDNESS LOUD LV1 */ LOUD LV2: Selects your preferred low and high frequencies boost to produce a well-balanced
sound at a low volume level. ; LOUD OFF: Cancels.
BALANCE
BAL L15 — BAL R15 (Preset: BAL 0): Adjusts the left and right speaker output balance.
FADER
FAD R15 — FAD F15 (Preset: FAD 0): Adjusts the rear and front speaker output balance.
SW SET
SW ON *: Turns on the subwoofer output. ; SW OFF: Cancels.
DTIL SET
LPF SW:
SW PHASE:
SPRM SET:
V-OFFSET:
(Preset:
V-OFF 0)
[SW LEVEL/ SW SET/ LPF SW/ SW PHASE] is selectable only if [SWPRE] is set to [SWPRE SW]. (page 6)
[SW LEVEL/ LPF SW/ SW PHASE] is selectable only if [SW SET] is set to [SW ON].
10
Selectable setting (Preset: *)
LPF THRU *: All signals are sent to the subwoofer. ; LPF 85H/ LPF 120H/ LPF 160H:
Frequencies higher than 85 Hz/ 120 Hz/ 160 Hz are cut off.
PHAS REV (180°)/ PHAS NML (0°) *: Selects the phase angle of the subwoofer output to be in
line with the speaker output for optimum performance. (Selectable only if a setting other than
[LPF THRU] is selected for [LPF SW].)
SPRM ON *: Creates realistic sound by interpolating the high-frequency components that are
lost in MP3/WMA audio compression. ; SPRM OFF: Cancels. (Selectable only when playback
an MP3/WMA disc or a USB device.)
V-OFF –8 — V-OFF +8 (for AUX) ; V-OFF –8 — V-OFF 0 (for other sources): Presets
the volume adjustment level of each source. The volume level will automatically increase or
decrease when you change the source. (Before making an adjustment, select the source you
want to adjust.)

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido