Installing The Unit; Installing Without Using The Mounting Sleeve (Japanese Car); Removing The Unit - Kenwood KDC-MP102U Manual De Instrucciones

Installing the unit

1
2
Before attaching, make
sure the direction of the
escutcheon is correct.
(Wider hooks on the
top side.)

Installing without using the mounting sleeve (Japanese car)

1 Remove the mounting sleeve and escutcheon from the unit.
2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and secure
the unit with the supplied screws.
T: Toyota cars ; N: Nissan cars

Removing the unit

1 Detach the faceplate.
2 Engage the catch pin on the
removal tools into the holes on
both sides of the escutcheon, then
pull it out.
3 Insert the removal tools deeply into
the slots on each side, then follow
the arrows instructions as shown
on the right.
14
Connect the wiring harness
to the unit. Other wiring
connection has been completed
earlier. (page 13)
Dashboard of your car
Bend the appropriate tabs
to hold the mounting
sleeve firmly in place.