Publicidad
Idiomas disponibles
Idiomas disponibles
Caution
Please Note:
1. When the unit is moved, please use the original
paper box and packing materials and use the
factory packing method to optimally protect
the unit.
2. Do not place volatile liquids beside the unit, and
do not allow rubber or plastic to make contact with
the unit for extended periods of time as these
products may mark the surface of the unit.
3. After the unit has been in use for a lengthy period
of time, it may heat up on top and at the rear plate.
This is normal.
4. When the unit is not used, please take out the
disc, close the disc door and turn the power off.
5. If you have not used the unit for a long time and
find that certain function keys are not working,
please refer the unit to qualified service
personnel for maintenance.
Location :
When your unit is placed near the TV, radio, or video
tape recorder, poor image quality and sound
distortion may occur. In that case, please relocate
the unit away from such equipment.
Cleaning:
1. Use a soft cloth to clean the unit.
2. Please use the cloth with a small amount of
diluted cleaning agent to deal with dirty spots
which are not easily cleaned. Do not use any
solvents with corrosive substances like diluted,
gasoline solvent, abrasive solution, etc. which will
damage the surface of the unit.
Warning: The cleaning and adjustment of internal
parts should be conducted by trained authorised
personnel.
Discs:
1. How to take care of your discs: Do not touch the
playing side of the disc.
2. How to clean your discs: Use a soft cloth to wipe
the disc from the centre out. Fingerprints and dust
remaining on the disc will affect the quality of the
image and sound. When cleaning stubborn dirt,
use a clean soft cloth dipped into a little water to
wipe the disc, then use a dry soft cloth to dry it.
Do not use solutions like methylbenzene,
cleaning agents or antistatic spray to clean the
disc.
3. How to store your discs: Do not place the discs in
a place with heavy moisture, dust or direct
sunlight. When the discs are not used, please
place them in their boxes.
Batteries:
Using the batteries incorrectly will cause leakage
or corrosion of the battery fluid. Please use the
batteries in accordance with
the following instructions:
1. Do not reverse the positive and negative
polarity when the batteries are inserted.
2. Do not recharge non-rechargeable batteries,
disassemble the batteries, make them short
circuit or throw them into a fire.
3. Do not mix different types of batteries or old and
new batteries .
4. Do not keep damaged batteries in the remote.
5. If the remote is not used for a long time, please
remove the batteries to avoid damage caused by
the leaking of the battery fluid.
6. If the remote is faulty or its effective scope is
reduced, please replace with new batteries.
7. If the batteries have leaked battery fluid, please
dry the battery box and replace with new batteries.
Remote Control:
Using the remote incorrectly will result in poor
performance. Please use the remote in accordance
with the following instructions:
1. The emitter of the remote should not be exposed
to sunlight.
2. Please aim the remote at the reception window of
the unit.
3. Do not drop the remote as it may get damaged.
4. Do not allow water or any other liquids to come
into contact with the remote.
5. Do not disassemble the remote.
Tips:
1.Correctly place the batteries inside the battery
box of the remote.
2.The maximum reception distance between the
remote and the unit is about 7m.
3.The maximum effective angle of the remote
aligning at the reception window is 30°.
3
System Connection
Description of Video Output Port:
Video Output
Connect to the video terminal of the TV.
(yellow)
TV Audio Cable:
Connect the audio cable to the TV audio terminal.
This wire is included in the accessories
Stereo Speaker Connecting Guide:
Right speaker
Please note:
1. When connecting speakers, please make sure the front, center and surround speakers are connected
correctly to the terminals. Do not short circuit the connections as this will cause damage to the system.
2. To connect correctly, connect red wire to "+", and black wire to "_".
(yellow)
TV
Video connecting wire
VIDEO IN
TV audio terminal
R
(red)
(red)
TV
L
(white)
(white)
left speaker
4
Publicidad
