Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Statement
Safety Precautions
1. Avoid dropping.
2. Do not disassemble this device.
3. Do not expose this device to rain or moisture or submerge in water.
4. Ideal temperatures are 0°C to 35°C. Avoid extreme temperatures.
5. Keep the device away from excessive heat, such as sunshine, fire or the like.
6. Do not use the device outdoors during thunderstorms.
7. Use original or certified cables.
8. Do not use any corrosive cleaner/oil to clean.
9. Keep out of reach of children. It contains small parts which may be a choking hazard.
10. Observe local laws and regulations while using the device.
11.To prevent damage to your device's parts or internal circuits, do not use it in dusty,
smoky, damp or dirty environments.
12. Do not use, store or transport the device where flammables or explosives are stored. Using
your device in these environments increases the risk of explosion or fire.
FCC Statement
FCC ID: 2A7A6-CAM1080
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation
between the equipment and receiver. (3) Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected. (4) Consult the dealer or
an experienced radio / TV technician for help.
COPYRIGHT © 2024 RCA. ALL RIGHTS RESERVED
This product has been manufactured and sold under the responsibility of SUMMIT
ELECTRONICS, LLC. RCA and the RCA logo are trademarks used under license by
SUMMIT ELECTRONICS, LLC. All other products, service, companies, trademarks, trade or
product names and logos referenced herein are the property of their respective owners.
EN 12
Publicidad
